Smarthome 2475SDB Manual de usuario descargar pdf (Pagina 7)

Page 7 of 12 2475SDB - Rev: 1/21/2014 7:58 AM

Advanced Features

Using In-LineLinc as a Phase Bridge (Phase Bridging Detection Mode)

In-LineLinc automatically bridges the electrical phases in your home (via communications with dual-band

devices on the “other phase”). Use the following procedure to confirm that phases are bridged via In-

LineLinc:

1) Start Phase Bridging Detection Mode by tapping the Set button on In-LineLinc four times quickly

In-LineLinc will begin (Beeping)

Other dual-band devices' LEDs will illuminate at 100% brightness

2) Check the LED behavior of the “other” dual-band devices

- If the “other” dual-band device is blinking green

i. it is within range and not on the same phase, proceed to next Step

- If they are not blinking green

i. Try moving the “other” device, check other dual-band devices or begin

test from a different initiator

3) Tap In-LineLinc’s Set Button

In-LineLinc will stop beeping and LED returns to previous state

Other devices’ LEDs will stop blinking

Restoring Power to In-LineLinc

In-LineLinc stores all of its settings, such as links to other INSTEON devices, with non-volatile memory.

Because settings are saved in this non-volatile memory, they will not be lost in the event of a power

failure.

In the event of a power loss In-LineLinc will automatically return the load to the state it had before power

was interrupted.

Or is simply blinking for single colored LEDs. If the “other” dual-band device is a KeypadLinc Dual-Band, the 4 middle LEDs will blink.

Or are not blinking at all for single colored LEDs. If the “other” dual-band device is a KeypadLinc, any LEDs that are on will go to full bright.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Smarthome 2475SDB Manual de usuario Pagina 7